Condensate Steam Stainless Steel Tube and Shell Heat Exchanger

Avoid Costly Failures Of Shell-And-Tube Heat

• Chemically Induced Corrosion Custom Heat Exchangers XchangerThe first heat exchanger stage uses 45ºF chilled water to cool and dehumidify the 2,280 SCFM, 4 PSIG air flow from 145ºF to 55ºF. The air, then at 100% RH passes through a mist eliminator to ensure no condensate droplets carry downstream. The second heat exchanger stage uses steam to heat air back to 95ºF, where it is at 23% RH.

  Heat Exchanger - Stainless Steel Tube Stainless Steel

  Heat Exchanger. Large Steam System Condensers. Stainless Steel Condenser Tube. The steam condenser, shown in Figure 9 below, is a major component of the steam cycle in power generation facilities. It is a closed space into which the steam exits the turbine and is forced to give up its latent heat Heat Exchangers & Tube Bundles - Keystone Steam SuppliesKeystone Steam Supplies has been supplying replacement tube bundles for over twenty years. We can assist you with your RTB. Tubes are available in Copper and Stainless Steel (both 304 and 316) while the tube sheet is available in Carbon Steel, Brass, or Stainless Steel (both 304 and 316).

  Heat Exchangers And Stall Spirax Sarco

  The hot steam in the top of the steam space will cause the heat exchanger to expand there, while the cool water in the bottom of the steam space has the reverse effect. This uneven expansion/contraction can cause mechanical stress to the heat exchanger structure, notably to the soldered, brazed, welded or expanded joints in plate and shell and tube heat exchangers, and air heater batteries. How to Trap:Shell and Tube Heat ExchangersOne type of submerged coil is the shell and tube heat exchanger (Fig. CG-45). In these exchangers, numerous tubes are installed in a housing or shell with confined free area. This ensures positive contact with the tubes by any fluid flowing in the shell. Although the term submerged coil implies that steam is in the tubes and the tubes are sub-merged in the liquid being heated, the reverse can also be true, where steam is in the shell and a liquid is in the tubes.

  SONDEX® Plate and shell heat exchangers (SPS) Danfoss

  SPS1200 plate and shell heat exchanger. Our SONDEX ® plate and shell heat exchangers (SPS) combine the strengths of both shell and tube heat exchangers and plate heat exchangers, retaining the high working pressure and temperatures of the former coupled with the high efficiency of the latter. A best of both worlds solution, our plate and shell heat exchangers provide unmatched performance for a wide range of applications, particularly vapor condensation Steam Consumption of Heat Exchangers Spirax SarcoA shell and tube heat exchanger consists of a bundle of tubes enclosed in a cylindrical shell. The ends of the tubes are fitted into tube sheets, which separate the primary and the secondary fluids. Where condensing steam is used as the heating medium, the heat exchanger is usually horizontal with condensation taking place inside the tubes.

  Steam heaters - the new generation

  shell-and-tube heat exchangers or conventional plate heat exchangers. The TS-M Series is the new generation of steam heaters. Together, the design and performance of the TS-M Series add up to greater lifecycle economy when heating water for industrial purposes. SONDEX® plate and shell heat exchangers (SPS)heat exchangers. Our SONDEX® plate and shell heat exchangers (SPS) are perfect choices for condensation and steam heating duties. A fully welded plate pack makes the heat exchangers well-suited for handling aggressive media as well as high pressure levels and temperatures. Less space demanding and much lighter in weight, they are good replacements for shell and tube heat exchangers.