Shell-and-tube heat exchanger. Our shell and tube heat exchangers are used in many comfort and industry applications for heating and cooling fluids. They consist of a shell with traditional plain tubes or enhanced surface tubes for high thermal performance. The fluids can be liquids or gases, one of which flows inside the tubes while the other
Example 5.2 Miniature Shell-and-Tube Heat Exchanger A miniature shell-and-tube heat exchanger is designed to cool engine oil in an engine with the engine coolant (50% ethylene glycol). The engine oil at a flow rate of 0.23 kg/s enters the exchanger at 120°C and leaves at 115°C. The 50% ethylene glycol at a rate of 0.47 kg/s enters at 90°C. Single-Stage Rotary Screw Air Compressors SullairUses shell and tube heat exchanger; Flange-Mounted Motor and Air End* Up to 5% energy savings over belt drive; Eliminates maintenance expense associated with V-belts; Premium Efficient Motor Direct coupled design for extended bearing life 250,000-hour insulation life; Sullair Supervisor Microprocessor Controller; Multi-Stage Air-Fluid Separation
offers 999 heat exchanger for sullair products. A wide variety of heat exchanger for sullair options are available to you, such as local service HC-824-4-4-F Shell And Tube Compressor Oil CoolerHC-824-4-4-F is Shell and Tube Heat Exchanger used to cool compressor oil with cooling water. Replacement oil coolers for the following compressor manufactures:Tecumseh, Quincy, Campbell Hausfeld, Chicago Pneumatic, Ingersoll-Rand, Jenny, Maxus, Powerex, Rolair, Atlas Copco, Sullair, Gardner Denver, Eaton, and more.
Jun 01, 2020 · A water-cooled aftercooler is a shell and tube heat exchanger used primarily in hot ambient environments where proper ventilation cannot be achieved. The water-cooled aftercooler will use cooling water to lower the compressed air discharge temperature to within 10 25° F above the inlet water temperature.
Your email address will not be published.*